A Heat Partition investigation of Multilayer Coated Carbide Tools for High Speed Machining through experimental studies and Finite Element Modelling

Access to files

•   FULL-TEXT.PDF (pdf)

Abstract

High Speed Machining (HSM) is associated with higher cutting velocities and table feedrates and higher material removal rate, lower cutting forces in contrast to conventional machining. HSM can be undertaken dry or near dry and hence it is considered as environmentally friendly machining in relation to the use of cutting fluids. A key challenge in HSM is that, the thermal loads generated during the cutting process can be a major driver of thermally activated wear mechanism and hence affect machining performance. The ability of cutting tools to act as thermal barrier can be a highly desirable property for dry and HSM. Recently, research work has been conducted on laboratory based coated cutting tools to model and understand the fraction of heat that enters the cutting tool. These studies have shown the potential for TiN and TiAlN coated tools in reducing heat partition to the cutting tool when compared to uncoated tools. This PhD extended this work to modelling and characterising the heat partition for new generation commercial coated cutting tools considering tools from major insert manufactures. For this study commercial coated carbide tools were classified into two groups. In one group were coatings uniformly applied on both rake and flank faces of the insert (SERIES). The second group were tools that had different top coats for the rake and flank faces (Functionally Graded). This concept of functional grading is used to tailor the coating selection to the conditions that exist on a tool face. Moreover, the issue of restricted chip contact was modelled and clarified in terms of its impact on heat partition. This chip breaker design is of particular importance to inserts used for machining ductile materials. Thus the PhD has applied research methods to industrial cutting tools and helped elucidate the important aspects relating to the design, layout and selection of multilayer coatings.The heat partition was quantified by using a combined Finite Element (FE) and experimental approach. This methodology was applied by taking into consideration the appropriate friction phenomena during HSM i.e. sticking and sliding. A restricted contact length with groove profile geometry was considered for the application of heat load in the FE model. Orthogonal and external turning of AISI/SAE 4140 medium carbon alloy steel was conducted over a wide range of cutting speeds. An infrared thermal imaging camera was used to measure cutting temperatures. The results show that the layout of the coating can significantly affect the heat distribution into the cutting tool, specifically; the top coat can alter the friction conditions between the tool-chip contact. The distribution of heat (heat partition) into the cutting tool insert with the thickest layer of Al2O3 as a top coating is the lowest in the entire range of cutting speeds tested i.e. 10.5% at lower cutting speed and reduced to 3.4% at highest cutting speed. Investigations were also conducted to quantify the contribution of heat from the primary and secondary deformation zones using a combination of finite element modelling, analytical modelling and experimental data. The results deduced that the primary deformation zone heat source contributes 9.1% (on average) to the heat partition into the cutting tool. The contribution of the Thesis should be of interest to those who design, manufacture and coat cutting tools. It defines heat partition values for commercial coated carbide tools, assesses the requirements for multilayer design of thermally insulating cutting tools, the selection of coating top layer coats and the role of contact phenomenon on heat partition in dry and HSM of steels.

Keyword(s)

Finite Element Modelling ; Functionally Graded Coated tools; Multilayer coated tools; Restricted contact length

Bibliographic metadata

Institutional metadata

Record metadata