Search the site

The University of Manchester Library

In April 2016 Manchester eScholar was replaced by the University of Manchester’s new Research Information Management System, Pure. In the autumn the University’s research outputs will be available to search and browse via a new Research Portal. Until then the University’s full publication record can be accessed via a temporary portal and the old eScholar content is available to search and browse via this archive.

FORMATION AND ATTACHMENT OF SOLIDS WITHIN A PIPELINE EMANATING FROM A NUCLEAR EFFLUENT TREATMENT PLANT

Jones, Robert

[Thesis]. Manchester, UK: The University of Manchester; 2018.

Access to files

Abstract

The Site Ion Exchange Plant (SIXEP) (Sellafield, Cumbria, UK) treats spent nuclear fuel storage pond liquors by utilising sand bed filtration to remove Mg containing particulates present in the effluent followed by an ion exchange process to remove Cs and Sr. Clinoptilolite (Na6Al6Si30O72.24H2O) the ion exchange media. After treatment the effluent is discharged to sea. During inspections of the discharge line a significant solid formation was encountered in the mid-2000s. The solid was poorly characterised and limited analysis was performed. At the time biofilm was suggested as the means of adhering a fine fraction of clinoptilolite to the pipeline surface. Three areas of study were investigated in order to identify the source and means of these solids adhering to the discharge pipeline surface. These were: the precipitation of mineral phases from a variety of possible discharge effluent compositions; the dissolution/degradation of clinoptilolite under process like conditions including ɣ-radiation exposure; and the demonstration of the performance of polyelectrolyte as an adsorption medium when contacted with a clinoptilolite solution onto stainless steel surfaces. Mineral phases from a range of likely SIXEP effluent compositions have been precipitated from static solution conditions. The predominantly aluminosilicate containing solids have similar characteristics (elemental composition and morphology) to the solid from the discharge line, but this is based upon limited and poor characterisation data from the recovered material. Dissolution studies of clinoptilolite displayed a fine fraction release into solution irrespective of the inclusion of a prewashing step. An incongruent release of Si from clinoptilolite was observed which was not considered in the original model put forward for this pipe fouling phenomenon. The presence of colloidal Si was found to increase in irradiated clinoptilolite samples (50 MGy total dose) when compared to un-irradiated material. Polyelectrolyte was found to cause fine fractions of clinoptilolite to adhere to a stainless steel surface (304L) and as a result provides an additional attachment mechanism for solids within the pipeline to what has been previously proposed. Following this work, it is suggested that the primary mechanism to justify this solids formation in the SIXEP discharge line is that the presence of polyelectrolyte and biofilms causes adsorption of clinoptilolite fines and colloids onto the inner pipe surface. Reprecipitation of aqueous species released through incongruent dissolution of the clinoptilolite should be considered as minor bulking agents to the main clinoptilolite fines solid.

Bibliographic metadata

Type of resource:
Content type:
Administered thesis
Form of thesis:
Alternative format
Type of submission:
Doctoral level ETD - final
Thesis title:
FORMATION AND ATTACHMENT OF SOLIDS WITHIN A PIPELINE EMANATING FROM A NUCLEAR EFFLUENT TREATMENT PLANT
Degree type:
Engineering Doctorate
Degree programme:
EngD Chemical Engineering & Analytical Science - Nuclear Engineering
Publication date:
2018-02-05T10:41:18
Institution:
The University of Manchester
Location:
Manchester, UK
Total pages:
300
Abstract:
The Site Ion Exchange Plant (SIXEP) (Sellafield, Cumbria, UK) treats spent nuclear fuel storage pond liquors by utilising sand bed filtration to remove Mg containing particulates present in the effluent followed by an ion exchange process to remove Cs and Sr. Clinoptilolite (Na6Al6Si30O72.24H2O) the ion exchange media. After treatment the effluent is discharged to sea. During inspections of the discharge line a significant solid formation was encountered in the mid-2000s. The solid was poorly characterised and limited analysis was performed. At the time biofilm was suggested as the means of adhering a fine fraction of clinoptilolite to the pipeline surface. Three areas of study were investigated in order to identify the source and means of these solids adhering to the discharge pipeline surface. These were: the precipitation of mineral phases from a variety of possible discharge effluent compositions; the dissolution/degradation of clinoptilolite under process like conditions including ɣ-radiation exposure; and the demonstration of the performance of polyelectrolyte as an adsorption medium when contacted with a clinoptilolite solution onto stainless steel surfaces. Mineral phases from a range of likely SIXEP effluent compositions have been precipitated from static solution conditions. The predominantly aluminosilicate containing solids have similar characteristics (elemental composition and morphology) to the solid from the discharge line, but this is based upon limited and poor characterisation data from the recovered material. Dissolution studies of clinoptilolite displayed a fine fraction release into solution irrespective of the inclusion of a prewashing step. An incongruent release of Si from clinoptilolite was observed which was not considered in the original model put forward for this pipe fouling phenomenon. The presence of colloidal Si was found to increase in irradiated clinoptilolite samples (50 MGy total dose) when compared to un-irradiated material. Polyelectrolyte was found to cause fine fractions of clinoptilolite to adhere to a stainless steel surface (304L) and as a result provides an additional attachment mechanism for solids within the pipeline to what has been previously proposed. Following this work, it is suggested that the primary mechanism to justify this solids formation in the SIXEP discharge line is that the presence of polyelectrolyte and biofilms causes adsorption of clinoptilolite fines and colloids onto the inner pipe surface. Reprecipitation of aqueous species released through incongruent dissolution of the clinoptilolite should be considered as minor bulking agents to the main clinoptilolite fines solid.
Additional digital content not deposited electronically:
none
Non-digital content not deposited electronically:
none
Keyword(s):
Thesis main supervisor(s):
Thesis co-supervisor(s):
Funder(s):
Degree grantor:
Language:
en

Institutional metadata

University researcher(s):
Academic department(s):

Record metadata

Manchester eScholar ID:
uk-ac-man-scw:313310
Created by:
Jones, Robert
Created:
5th February, 2018, 10:41:18
Last modified by:
Jones, Robert
Last modified:
4th January, 2021, 11:37:27

Can we help?

The library chat service will be available from 11am-3pm Monday to Friday (excluding Bank Holidays). You can also email your enquiry to us.