In April 2016 Manchester eScholar was replaced by the University of Manchester’s new Research Information Management System, Pure. In the autumn the University’s research outputs will be available to search and browse via a new Research Portal. Until then the University’s full publication record can be accessed via a temporary portal and the old eScholar content is available to search and browse via this archive.

Related resources

Search for item elsewhere

University researcher(s)

Academic department(s)

Digital average-current control for the dual interleaved boost converter

Villarruel-Parra, Alejandro

[Thesis]. Manchester, UK: The University of Manchester; 2015.

Access to files

FULL-TEXT.PDF (pdf)

Abstract

This Thesis addressed the challenge of ensuring balanced currents in the phases of a multi-kW, interleaved dc-dc converter by means of closed-loop digital control. The Thesis examines uniformly-sampled, valley-current, peak-current and average-current control for a dual interleaved boost converter with inter-phase transformer which might form part of the power train of an electric vehicle. Also, an enhancement of the average-current control is investigated in which the transistor duty-ratio is updated more rapidly, which allows an improvement of approximately ten times in the response speed of the system. Based on the theoretical analysis, the average-current control methodology was determined to be the most suitable technique for this type of converter as it ensures well-balanced phase currents over a wide range.To provide a basis for control system analysis and design for interleaved converters, a modelling methodology is developed based on a combination of multi-rate data-sampled theory and a small-signal averaged converter model. The model is shown to represent accurately the interaction between the interleaved phases, revealing a reduced stability range compared with a non-interleaved converter.The modelling and control methods are validated using switched and average value simulations obtained with the SABER software and by experimental results from a 25 kW, 30 kHz converter prototype. The control techniques were implemented on a Texas Instruments TMS320F28335 digital signal controller.